Hign-concerned Chemical:NoneItem Width:30CM,50CMItem Length:DIYMaterial:PVCType:Glossy FilmOrigin:Mainland ChinaSpecifications: Product Name: PET High Gloss Vinyl Wrap Color: BLACK Size: 30cm,50cm x 0.5m,1.52m,2m,3m Material: PET Vinyl Surface: High Glossy AdhesiveLifespan: 3-5 Years outdoors Package:Wrap Film x 1 Application: It is recommended to use a smooth paint surface. Car - Interior, rearview mirror, center pillar Motorcycle - Body Paint Surface Installation Method of Car Vinyl Wrap: 1. Prepare the surface: Clean the car's exterior thoroughly to remove any dirt, grease, or wax. Make sure the surface is dry and smooth for optimum adhesion. 2. Measure and cut: Measure the dimensions of the area you want to wrap and cut the vinyl wrap accordingly, leaving extra material for trimming. 3. Apply heat: Warm the vinyl wrap with a heat gun or hairdryer to make it more pliable and easier to manipulate during installation. 4. Peel and stick: Slowly peel off the backing paper from the vinyl wrap, ensuring the adhesive side does not touch anything before applying it to the desired surface. Start from one end and gradually press the wrap onto the car's surface, using a squeegee to remove air bubbles and ensure a smooth application. 5. Trim excess: Once the vinyl wrap is in place, trim any excess material using a sharp utility knife or blade. Take extra care around edges, curves, and contours for a precise and professional finish. 6. Heat and stretch: Use heat again to apply gentle and even heat to the vinyl wrap's surface, helping it conform to the shape of the car and removing any remaining wrinkles or bubbles. 7. Final touches: Once the wrap is fully installed, use the heat gun to heat the entire surface and activate the adhesive for better bonding. Then, use a cloth or microfiber towel to give it a final smooth