and<br> PICKIT3 Programmer USB (Full speed 12 Mbits/s interface to host PC) Real-time execution. MPLAB IDE compatible (free copy included)<br> The MPLAB PICkit 3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE).<br> The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE)<br> Supports low voltage to 2.0 volts (2.0v to 6.0v range)<br> Diagnostic LEDs (power, busy, error)<br> Read/write program and data memory of microcontroller<br> Erase of program memory space with verification<br> Freeze-peripherals at breakpoint<br> Program up to 512K byte flash with the Programmer-to-Go<br> Instructions for use:<br> Installing the microcontroller, 28-pin, 40-pin microcontroller left aligned 28/40P (A) This flag line short-circuit cap on the A position<br> The 8,14,18,20-pin microcontroller aligned on the left 8P/14P/18P/20P flag line (B), shorting cap on the B position<br> The ICD2, KIT2, KIT3 crystal head or 6Pin Block programming connection for programming the programming operation. (Note: a separate program of the seat can not be programmed the chip is programmed functions)<br> The seat supports the following programming microcontroller:<br> PIC16/18XX 40PIN Series devices (except 16F59)<br> PIC16/18XX 28PIN Series devices (except 16F57)<br> PIC16/18XX 18PIN Series devices<br> The PIC 8PIN/14PIN/20PIN family of devices (except 10FXX)<br> Colour:Red<br> Material:plastic<br> Size:14.5 x 7 x 4CM<br> Package Contents:<br> 1 * PICKIT3 Simulator<br> 1 * USB Cable<br> 1 * 6Pin cable<br> 1 * Universal Programmer Seat<br> Only the above package content, other products are not included.<br> Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +