PIR Sensor Solar Wall Light

Dimensions: Not specified in source. Weight: Not specified. Battery: Dual 3.7V 2000mAh lithium batteries (total 4000mAh capacity) with charge/discharge protection. Solar panel: Monocrystalline silicon, 5.5V, 1.43W. Total LED power: 50W. Light source: SMD2835 white LEDs. Material: Durable ABS housing. IP65 water-resistant rating — suitable for rain, snow and fog. Charging time: 6 hours under direct sunlight. Full-charge runtime: Over 10 hours in low-light mode; motion-triggered high-brightness mode lasts 15–30 seconds per activation with 20–25s delay. Detection angle: 270° horizontal coverage. Detection distance: 8–10 metres. Mounting height recommendation: Within 3 metres for optimal sensor and solar exposure. Control modes: Light-sensing + PIR motion activation. Four lighting modes via button: OFF / Motion-only (high light, 15–30s) / Motion + low-light standby (high light when triggered, low light otherwise) / Always-on low light. The lamp automatically charges during daylight and activates only in darkness — it will not operate during daytime due to built-in light sensor logic. For reliable performance, install with solar panel facing upward, unobstructed, and in full sun. Ensure mounting surface allows secure wall fixation using included screws and expansion pipe. Ideal for outdoor wall mounting on houses, garages, sheds, gates or pathways — no wiring required. Easy DIY installation thanks to wireless solar design.