PS1248G 4Pairs High-Power active splitters enable data terminals that were not originally designed to accept power from the Ethernet, to be powered by Power over Ethernet midspans. The PDAS- PS1248-4P splitter can power devices such as WiMAX CPEs, small WiMAX base-stations, 802.11n Access-Points, Thin- Clients, PTZ (Pan/Tilt/Zoom) IP Cameras, Video-Phones and more. Moreover, such devices might only accept voltage levels lower than the PoE standard minimum voltage (44v in IEEE802.3af / 50v in 802.3at). Using the PS1248-4P splitter, these terminals immediately become PoE- without any modification required on their side. The splitter is identified as a powered device (PD) in front of the powering Midspan and after being detected and powered, it physically splits the data and power streams, arriving over a single cable, into wo separate (LAN & DC) which go directly to the data terminal. Voltage regulation is also performed to the level required by the terminal . : 2 x RJ-45, shielded, EIA 568A and 568B DC Jacks On unit: 5.5X2.1mm Data Rate: 10/100/1000 Input voltage: 44 - 57 Input power: 60W max Output power: 51W max Output Current: 4.2A@12V Indicators :Output Power Indicators: Green LED Environmental Operating Temp: -20 to 40 Celsius Storage Temp: -30 to 70 Celsius Operating Humidity: 10% to 90%, non-condensing Storage Humidity: 5% to 95%, non-condensing colour:black material:metal size:8 x 6.2 x 2.7 Cm Package Contents: 1xPS1248G Gigabit POE splitter Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.