PWM DC Motor Adjustable Speed Controller 12V 24V 48V Forward Reverse

Function Introduction1. Soft start time setting: 000-100 (0-10 seconds) adjustable, default 1 second2. Soft stop time setting: 000-100 (0-10 seconds) adjustable, default 1 second3. Maximum Speed Scale Setting: 000-9990 (0-9990), default 1004. Speed lower limit setting: 000-9980 (0-9980) adjustable, default 05. Speed upper limit setting: 000-9980 (0-9980) adjustable, default 100Note: For the above 3 functions, thousands of bits will flash and not be displayed if the value in the setting interface exceeds 999 bits6. Speed increase/decrease value setting: 001 002 005 010 015 020 025 050 100. Each press of the increase/decrease button changes the speed by the corresponding value7. Power on start mode: Mode 1: Motor does not start after power on; Mode 2: Starts after power on, default mode 18. Total running time setting: 0~99:59:59 can be set. All 0 means no timing, default 09. Forward rotation time setting: 0~99:59:59 can be set, default 10 seconds10. Stop time setting: 0~99:59:59 can be set, default 10 seconds11. Reverse time setting: 0~99:59:59 can be set, default 10 secondsNote: Long press the setting button for 2 seconds to switch between hours, minutes, and seconds for the above 3 functions12. Manual automatic mode selection: Mode 1 is manual mode (functions 8, 9, 10, 11 do not take effect); Mode 2 is automatic mode (functions 8, 9, 10, 11 take effect)ParametersInput voltage: DC 6-55VMaximum current: 20ADisplay method: LCD color screenForward and reverse: bidirectionalSpeed regulation method: button and knobWireless remote control: YesSupported load: compatible with DC brushless motorInstallation method: embeddedWiring type: fence type terminalNet weight of product: 95g+25gProduct size: width 77mm x height 57mm x thickness 38mmOpening size: width 72mm x height 52mmMaterial: PlasticWiring InstructionsInput voltage ranges within 6-55V DC (the specific voltage shall be equal to the rated voltage of the motor)- Input power positive terminal- Power negative terminal- Motor positive terminal- Motor negative terminalOperation Guide1. Remote control code matching: Long press the setting button, then power on, press any key on the remote control once. The backlight flashes twice, which indicates code matching is successful2. Restore factory settings: Enter the settings interface, press and hold the setting button for 6 seconds, the backlight flashes twice, which indicates factory settings restoration is successful3. Appearance difference due to different product batches will not affect usePackage Contents1 x Speed Controller1 x Remote control