Radiomaster RP3H ExpressLRS ELRS 2.4GHz Nano Receiver with Builtin TCXO for Pocket Boxer Zorro TX16S Mark Radio Transmitter Precise details: Designed specifically for use with our Nexus Helicopter Flybarless control unit and compatible with all CRSF/S.BUS enabled flight controllers the RP3H ExpressLRS receiver comes with a builtin TCXO and an integrated housing design that makes the receiver tougher and ready to mount in modern helicopter frames. With the RP3H receiver, you can get reliable, stable, and accurate signal reception, which enhances your flight experience and allows for superior performance even in demanding environments. The RP3H also features an ExtV telemetry input for compatibility with older ESCs that do not provide battery voltage telemetry via the control unit. The RP3H receiver uses the Skyworks SKY66112 power amplifier to increase telemetry performance, the PA provides up to 100mw of telemetry power, and antenna switching for antenna diversity. It is developed around the ESP8285 MCU and SX1281IMLTRT RF Chip, offering Lora and FLRC 2.4GHz RF links that provide incredible range and low latency. With Wifi builtin, firmware updates can be done on your craft without the need to remove the receiver. Features: Perfect for helicopters and any application that needs a rugged cased serial receiver Plug'n'play solder free RP3H ExpressLRS receivers compatible with NEXUS Heli flight controller Optimized PCB design for better heat dissipation LNA for better receiver range PA for better telemetry range Antenna Diversity for improved signal stability and range Builtin a TCXO (temperature compensated crystal oscillator) Automatically detects voltage telemetry of external battery voltage or receiver battery/ESC BEC voltage Compatible with all 2.4GHz ExpressLRS modules and transmitters with built in 2.4GHz ExpressLRS Specifications: Brand: Radiomaster Item: RP3-H ExpressLRS 2.4GHz Nano Receiver Type: ISM MCU: ESP8285 RF Chip: SX1281 Telemetry RF power: Max 100mW Antenna: 150mm 2.4GHz Antenna x2 Frequency Range: 2.404 2.479 GHz Maximum receive refresh rate: 500Hz / F1000Hz Minimum receiver refresh rate: 25Hz Working voltage: DC 4.5-8.4V Battery voltage detection range: DC 4.0-35V Weight: 5.1g (Including two antenna) Dimension: 28mm*24mm*8mm Firmware Version: ExpressLRS v3.3.1 preinstalled FW Target: RadioMaster RP3-H Diversity 2400 RX Bus interface: CRSF/S.Bus Package Includes: 1 * RP3H ExpressLRS 2.4GHz Nano Receiver 2 * 150mm IPX1 2.4GHz T Antenna (installed) 1 * JSTGH CRSF 4 wire Pigtail 1 * JSTGH 4 wire to JSTGH CRSF cable 1 * JSTGH 4 wire to single Servo pin (single dupont connectors) 1 * Voltage telemetry wire 1 * Quick start guide