Works with specific standard 90-degree jacks (CAT5, CAT6, and CAT6a shielded). Simply seat all 8 wires into the 90-degree punch-down type jack, then insert the jack into the tool. One-handed operation allows you to punch down and trim all 4 pairs of your Ethernet cable into a 90-degree jack with a single crimp. This saves time by enabling simultaneous wire termination with a quick squeeze of the tool. Ergonomically designed handle is easy to use, seating and cutting all wires at once while reducing hand fatigue. The tool also cuts off excess wire, ensuring a clean and precise jack every time. Increases termination speed and accuracy significantly. Keeps RJ45 jacks neat and organized during network cable installation. Helps prevent damage to jacks or Ethernet cables. Color: Green. Material: Metal. Package contents: 1 x 90-Degree Termination Tool. Only the listed item is included; other products are not included. Note: Lighting and display differences may cause slight color variations between the image and the actual item. Measurement may vary by +/- 1-3 cm.