UT-2201 interface supports 2 communication modes as below:1. Point-to-point 2 wires half-duplex2. Point-to-multipoint 2 wires half-duplexWhen converter works under half-duplex connection, it needs to install a matching resistance (data 120 ohm1/4W) for preventing signal reflection and interference.UT-2201 half-duplex communication connect between interface converter1. Interface feature: -232C, -485 standard interface compatible with EIA 2. Electric interface: -232 end DB9 hole connector -485 end DB9 needle connector with connection pole.3. Working mode: asynchronism half-duplex (-485)4. Transmission media: twisted -pair or STP5. Transmission rate: 300-115.2KBPS6. External discharge dimension: 63mm x 33mm x 17mm7. Working circumstance: - 25 to 70 degree C, relative humidity 5%to95%8. Transmission distance: 1,200m(-485 end) 5m(-232 end)9. : DOS/WIN95/WIN98/WIN2000/NI/XP/Linux and so on10. Applies to all communication software, plug and pay11. Max 32 pieces face devices can connect12. Power: Unique serial port charge pump driving technology, no need external power, real 3 wire communication (TXD, RXD, GND), no need initialize serial port13. Auto send/receive data, without external flow control signal ()14. serial port rs232material: plasticColor as shownPackage Contents:1 x RS232 TO RS485 ConverterOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.