AD-FMCOMMS3-EBZ is a high speed analog module designed to demonstrate the AD9361 - a high performance, highly integrated RF transceiver designed for RF applications such as 3G and 4G base stations and test equipment applications, software defined radios. The programmability and wideband capabilities of this device perfect for a of transceiver applications. The device combines an RF front-end with a flexible mixed-signal baseband section, an integrated frequency synthesizer, and a configurable digital interface to a processor or FPGA to simplify design-in. The AD9361 chip operates in a frequency range of 70 MHz to 6 GHz, covering licensed and frequency bands. By programming the AD9361 itself to change the sampling rate, digital filter and decimation parameters, the chip supports a channel bandwidth range of less than 200 kHz to 56 MHz. The AD-FMCOMMS[234]-EBZ card is a high-speed analog module designed to demonstrate the AD9361, a high performance, highly integrated RF agile transceiver designed for use in RF such as 3G and 4G base stations and SW software-defined radios . Now software radio product development and RF chip verification use this board. RF 2 x 2 transceiver with 12-bit DAC and TX Band: 47 MHz to 6.0 GHz Band: 70 MHz to 6.0 GHz Supports TDD and FDD operations Tunable channel bandwidth: Less than 200 kHz to 56 MHz Dual channel receiver: 6 differential or 12 single-ended inputs receiver sensitivity with 2 dB noise (800 MHz LO) gain control Real-time monitoring and control of signals for manual gain automatic gain control Dual transmitters: 4 differential outputs High Linearity Broadband Transmitter TX : 40 dB TX noise: 157 dBm/Hz noise floor TX Monitor: Dynamic Range 66 dB, Accuracy = 1 dB Integrated Fractional-N Frequency Synthesizer 2.4 Hz maximum local oscillator (LO) step size Multi-device synchronization CMOS/LVDS digital interface color:Blue Material:metal+plastic Package Contents: 1 x AD9361 RF board set Only the above package content, other are not included. Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.