Low-Output Mode Specifications - Sinusoidal output with harmonics at least 40 dB below the fundamental - Output frequency range: 100 kHz to 350 MHz - Output level adjustable in 1 dB steps from -76 dBm to -6 dBm Key benefits - Provides a clean sine signal with low harmonic content to minimize interference and measurement error in sensitive RF tests - Precise level control with 1 dB steps enables repeatable and accurate signal levels for calibration, characterization, and verification - Broad frequency coverage from 100 kHz to 350 MHz supports a wide range of RF test scenarios and instrumentation - Designed to integrate with standard RF test setups, supporting reliable performance in laboratory environments Use scenarios - Calibrating RF front-end components, filters, and mixers in a benchtop lab setup that requires a clean, low-level sine signal - Testing receiver sensitivity and linearity by injecting a known tone across the frequency range and adjusting the level in 1 dB increments - Providing a stable reference tone for spectrum analyzers and other measurement instruments during calibration and verification