Usage Tips:About this item [Fitment]The gas cap replacements fit for Toro, , and Troybuilt mower with & Stratton B&S 675exi 725exi series engines. Please match the fitment and measurements to an appropriate fit. [Part Number]594061 Cap Fuel Tank replaces part number#: 594061, 597414, 84004416. It is an exact replacement for your lawnmower fuel cap. [Quality Material]Our fuel tank caps are manufactured of durable, tough primary materials that increase the and dependability of your lawnmowers. It performs a number of vital duties, including preventing gas tank odors from exiting the tank, safeguarding the gasoline from outside contamination, and maintaining proper fuel tank pressure. [Easy to Install]Direct replacement for your lawn mower engine. Just disconnect the old gas cap and screw the one onto the gas tank. Note: Some lawnmowers may require an additional "O" Ring or gasket to stay on securely. [Seal Snugly]The issue caps is that they can become loose due to cracked, worn out, or stripped threads over time, in which case the cap should be replaced. Our gas fuel tank caps have a good seal and will not come off due to rubbing on low branches. It is recommended that you use this cap with an additional gasket to make the cap fit more snugly. Part number:594061 Fit for B & S 675Exi 725Exi Series engines This part is compatible with the following: 093J02-0093-F1, 093J02-0119-F1, 093J02-0121-F1, 103M02-0001-F1, 103M02-0002-F1, 103M02-0003-F1, 103M02-0004-F1, 103M02-0005-F1, 103M02-0006-F1, 103M02-0007-F1, 103M02-0008-F1, 103M02-0009-H1, 103M02-0010-H1, 103M02-0011-H1, 103M02-0012-H1, 103M02-0014-H1, 103M02-0015-H1, 103M02-0017-H1, 103M02-0019-H1, 103M02-0020-H1, 103M02-0021-H1, 103M02-0022-H1, 103M02-0023-F1, 103M02-0028-F1, 103M02-0029-H1. color: Black material: plastic Package Contents: 2x Fuel tank cap Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.