Countersunkhead TStar drive wood screw model 0191010350303 designed for secure, neat fastening in timber and composite materials. Key benefits Clean, flush finish: countersunk head sits below the surface for a smooth, professional appearance. Faster, cleaner starts: 4CUT point reduces splitting and lowers the need for pilot holes when working near edges or with thin boards. Strong clamping action: partial thread concentrates gripping power where it matters, pulling materials tight while allowing fast alignment. Corrosion protection: through clear zinc galvanising improves durability and weather resistance for exterior and semiexposed applications. Reliable drive engagement: TStar drive reduces camout and improves torque transfer for consistent installation with compatible bits. Features and important attributes Drive type: TStar (compatible with TStar driver bits and impact drivers designed for TStar interfaces) Head type: countersunk for flush fitting Point technology: 4CUT for reduced splitting and efficient penetration Thread: partial thread to maximize clamping strength between joined parts Finish: through clear zinc galvanising for corrosion resistance and uniform appearance Model and codes: 0191010350303, additional identifiers 0/1050/001/6,0/120/ /01 Practical use scenarios Decking and exterior joinery: fasten deck boards and trim where a flush head and corrosionresistant finish are required. Furniture assembly and interior trim: secure components with a neat countersunk finish and strong clamping from partial threads. Subframes and fencing: drive directly into joists or posts with reduced splitting and dependable holding power. Compatibility and performance tips Use the correct TStar driver bit for torque transfer and to minimize camout. For very dense hardwoods or closeedge fixing, consider a pilot hole to further reduce splitting despite the 4CUT point. Clean and dry surfaces before installation to maintain the integrity of the zinc finish. This screw combines a countersunk head, 4CUT point, partial thread, and clear zinc galvanising for dependable fastening in a wide range of carpentry and construction tasks. Model 0191010350303 corresponds to the listed technical identifiers 0/1050/001/6,0/120/ /01.