Two flow sensor switches, plastic gravity type, FS G 1/2 inch double external thread

1. The flow switch features high sensitivity and durability. 2. The flow switch consists of a magnetic core, a return spring, a forged copper or polycarbonate housing, and a sensor. 3. The housing is made of H58 forged copper or polycarbonate, the magnetic core uses a neodymium iron boron permanent magnet, and the sensor magnetic switch is a power element. 4. Both inlet and outlet have G1/2-inch standard pipe threads, ensuring a tight connection and stable performance. 5. Suitable for water circulation control, inlet/outlet water control, hot water control, water pump on/off control, solenoid valve on/off control, water outlet power cut-off, and water outlet power control, etc. Product Type: Water Flow Sensor Switch Model: FS G1/2 Double External Thread Working Voltage: DC 0-210V Working Current: 0.5-1A Working Temperature: -10~85℃ Maximum Temperature Resistance: 85℃ Working Pressure: 0.2 (MPa) Medium Specific Gravity: 0.7 Thread Size: Double External Thread G1/2 Minimum Starting Flow: ≥0.75 L/min Maximum Flow: ≤5 L/min Rated Working Pressure: ≤0.65 MPa Maximum Housing Pressure: ≤1.5 MPa Signal Output Load: DC 24V/0.5A, 36V/0.5A or AC 220V/0.1A Scope of Application and Conditions 1) Ambient temperature not lower than 0℃. Do not strike the housing. (1) Keep away from magnetic objects 2) The signal output is a switch value, so the connection method of the controlled object must also be a switch control relationship 3) The power of the controlled object must not exceed the signal load capacity 4) This device is a water medium control device and cannot be used for the control of other media. When the water flow rate in the pipeline exceeds 0.75 L/min, the magnetic core is displaced by the water flow, driving the magnetic source to generate a magnetic control effect, causing the sensor to output a "1" switching signal. After amplification, water flow control can be achieved. When the water flow rate in the pipeline is less than 0.75 L/min, the magnetic core drives the magnetic source to reset under the action of the reset spring, causing the sensor to output a "0" switching signal, and the system stops operating. Recommended for use with small relays. 2 water flow sensor switches.