- The circular clamping surface allows force to be applied from any angle, delivering high peak accuracy and reducing misalignment. - Small, compact blocks replace the clutter of fixed-angle mitre blocks and simplify setup for a wide range of joints. - They not only accommodate almost any mitre connection, but also tension and secure difficult joints such as shell joints, chamfers and grooves, as well as tenon joints where the pin passes through the groove. - They are effective for clamping simple 90-degree connections to large components when long clamps aren’t available; a straightforward tool whose utility is limited only by your imagination. Use scenarios - When assembling mitre joints at non-standard angles, enabling precise clamping pressure from the needed direction without swapping blocks. - For tensioning shell joints, chamfers, grooves, or through-groove tenon joints during fabrication to maintain alignment while set or bonded. - For large panels or components that require 90-degree clamping where conventional clamps are too short to reach.