1. Latest includes PIC25K80 and CH340T. 2. Manufactured modification to include a switch to connect to different CAN buses, MS CAN bus and CAN bus. 3. Designed For software, compatible with software venders; For , For , For FF2 and For FoCCCus, plus more.Support Windows XP and WIN7 32bite. 4. Basic Features:Reset fault /trouble codes / parameter (PIDs),Change car configuration data,Run tests, procedures,Program certain models 5. With the cable and of the supported software vendors you can detected modules which are not visible for regular OBD2 scanners. This includes showing you trouble codes, PIDs, running tests and procedures which are never displayed by other OBD2 scanners and a standard . OBDII Protocols: SAE J1850 PWM (41.6Kbaud) SAE J1850 VPW (10.4Kbaud) ISO9141-2 (5 baud init, 10.4Kbaud) ISO14230-4 KWP (5 baud init,10.4 Kbaud) ISO14230-4 KWP (fast init,10.4 Kbaud) ISO15765-4 CAN (11bit ID,500 Kbaud) ISO15765-4 CAN (29bit ID,500 Kbaud) ISO15765-4 CAN (11bit ID,250 Kbaud) ISO15765-4 CAN (29bit ID,250 Kbaud) SAE J1939 CAN (29bit ID,250*Kbaud) CAN (11*bit ID, 125*Kbaud) CAN (11*bit ID, 50*Kbaud) Pin Configurations: Switch position one: CAN - Occupies pins 6 and 14 Switch position two:MS CAN - Occupies pins 3 and 11 Supported Software: For For For FoCCCus For FF2 Plus more Please note that many models (approximately since 2003-2004) are equipped with MS CAN bus, in addition to the regular CAN bus. In contrast to CAN bus, MS CAN bus is not supported by the stock , because MS CAN is a manufacturer-specific solution and located on non-OBD2 pins. This has been modified to allow it to implement the MS CAN bus. supports For CAN from the stock, because For CAN completely matches to the OBD2 standards. It occupies pins 6 and14. MS CAN bus occupies pins 3 and 11. Supported Vehicles:Many vehicles that can be addressed using an via an OBDII connector. Colour:As Shown Material:plastic Package Contents: 1 x Diagnostic Interface Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.