Vector Inverter Variable Frequency Drive Converter for 2.2KW 3HP Motor AC380V Input 0‑380V Output Item Type: Frequency Converter Material: Flame Retardant ABS Input: 3PH AC380V±15% 5.8A 50-60Hz Output: 3PH AC0-380V 5.1A 0-400Hz Power Capacity: 4.0KVA Suitable Motor: 2.2KW 3HPOvervoltage Suppression Protection: When the bus voltage reaches or exceeds the bus overvoltage suppression point during the operation of the frequency converter, the frequency converter will automatically adjust the operating frequency to suppress the rise of the bus voltage, thereby ensuring that the frequency converter does not cause overvoltage protection due to excessive bus voltage. Overcurrent Suppression Protection: During operation, through real time monitoring of the load current, it automatically limits it to not exceed the set overcurrent suppression point to prevent fault tripping caused by excessive current. This function is particularly suitable for loads with large inertia or severe changes. Type Terminal Sign Terminal Name Description Power Supply 10V GND External +10V Power Supply External supply of +10V power supply, maximum output current: 150mA (with short circuit protection)Generally used as an external potentiometer working power supply,Potentiometer resistance range: 1-5kΩ 24V COM External +24V Power Supply External supply of +24V power, generally used as digital input and output terminalsPower supply and external sensor power supplyMaximum output current: 200mA Analog Terminal Al1 GND Analog Input Terminal 1 Input Range: DC0-10V 0-20mA, determined by parameter P437 Al2 GND Analog Input Terminal 2 Input Range: DC0-10V 0-20mA, determined by parameter P4-37 AO1 GND Analog Output Terminal 1 Output Current Range: 0mA-20mA, 4-20mA (P5-23 selectable) AO2 GND Analog Output Terminal 2 No current output functionJ1 jumper cap on isolated main control board to AO2 position, non isolated main control boardThe control board does not have this function Digital Input X1 COM Digital Input 1 HD1 (X5) can also be used as a high speed pulse input channel in addition to X1-X4 featuresMaximum input frequency: 50kHzInput impedance: 1kΩ X2 COM Digital Input 2 X3 COM Digital Input 3 X4 COM Digital Input 4 HDI COM (X5 Terminal) Digital input 5High Speed Pulse Input Terminal A+ B- RS485 Comm A+ is the positive input of the 485 communication differential signal, B- is the negative input of the differential signal Digital Output Y1 COM Open Collector Output When used as a collector open circuit output terminal (J1 jumper cap on the 90 isolated main control board to the AO2 position) HDO COM High Speed Pulse Output Restricted by the function code P5-00 HDO terminal output mode selection, output as a high speed pulse with a maximum frequency of 50kHz; When output as a collector open circuit, the same as Y1 K1A K1B K1C Relay 1 Terminal Contact Description: A: Common Point, B: Normally Closed Point, C: Normally Open PointContact Driving Capacity: AC250V, 3A; DC 30V, 1A K2A K2B K2C Relay 2 Terminal